|
Size: 1356
Comment:
|
Size: 923
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 10: | Line 10: |
---- /!\ '''End of edit conflict''' ---- |
|
| Line 16: | Line 14: |
---- /!\ '''Edit conflict - other version:''' ---- |
|
| Line 19: | Line 15: |
---- /!\ '''Edit conflict - your version:''' ---- {{ attachment:parts.jpg | | width=640 }} ---- /!\ '''End of edit conflict''' ---- |
|
| Line 27: | Line 18: |
---- /!\ '''Edit conflict - other version:''' ---- |
|
| Line 30: | Line 19: |
---- /!\ '''Edit conflict - your version:''' ---- {{ attachment:tools.jpg | | width=640 }} ---- /!\ '''End of edit conflict''' ---- |
HoseSplitter
Hose splitters can feed two hoses from one hose or spigot. Sadly, some have tiny little plastic valve knobs which are difficult to turn. Fortunately, these knobs can be extended with longer handles, which can be made from the (bent) wire handles of an ACCO binder clip, bent washers, and a longer attachment screw.
The unlabeled brass-and-plastic hose splitter (after modification) is shown here:
The bent wire handles provide a longer and easier to turn lever. Each handle is held in place with a bent washer (intended for a #10 machine screw) plus a longer screw that replaces the original screw that held the small plastic handle.
Here are the parts:
Here are the tools that I used:
