|
Size: 1356
Comment:
|
Size: 876
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 8: | Line 8: |
| [[ click for high resolution view |attachment:closeup.jpg ]] | |
| Line 10: | Line 9: |
| The bent wire handles provide a longer and easier to turn lever. Each handle is held in place with a bent washer (intended for a #10 machine screw) plus a longer screw that replaces the original screw that held the small plastic handle. | |
| Line 11: | Line 11: |
| ---- /!\ '''End of edit conflict''' ---- The bent wire handles provide a longer and easier to turn lever. Each handle is held in place with a bent washer (intended for a #10 machine screw) plus a longer screw that replaces the original screw that held the small plastic handle. |
---- |
| Line 16: | Line 15: |
---- /!\ '''Edit conflict - other version:''' ---- |
|
| Line 20: | Line 17: |
| ---- /!\ '''Edit conflict - your version:''' ---- {{ attachment:parts.jpg | | width=640 }} ---- /!\ '''End of edit conflict''' ---- |
---- |
| Line 27: | Line 21: |
---- /!\ '''Edit conflict - other version:''' ---- |
|
| Line 30: | Line 22: |
---- /!\ '''Edit conflict - your version:''' ---- {{ attachment:tools.jpg | | width=640 }} ---- /!\ '''End of edit conflict''' ---- |
HoseSplitter
Hose splitters can feed two hoses from one hose or spigot. Sadly, some have tiny little plastic valve knobs which are difficult to turn. Fortunately, these knobs can be extended with longer handles, which can be made from the (bent) wire handles of an ACCO binder clip, bent washers, and a longer attachment screw.
The unlabeled brass-and-plastic hose splitter (after modification) is shown here:
The bent wire handles provide a longer and easier to turn lever. Each handle is held in place with a bent washer (intended for a #10 machine screw) plus a longer screw that replaces the original screw that held the small plastic handle.
Here are the parts:
Here are the tools that I used:
